| View previous topic :: View next topic |
| Author |
Message |
Visitor
Superwoman 4
Joined: 23 Feb 2006
Posts: 675
|
 Posted: Wed Jan 20, 2010 9:04 pm Post subject: Mounting hardware for center pleated balloon shade |
 |
|
Hello, i am making a center pleated balloon shade which will be drawn up on the sides only. The shade will be 41" x 74". I purchase two pullys, one for each end of the shade, and a cord lock. If the pully is to be mounted in line with the lifting rings, where do i mount the cord lock? Or can i replace one pully with the cord lock? Also wha would be your recommendation for placement of rings?
Shar |
|
| Back to top |
|
 |
Debby Bowman
Moderator
Joined: 20 Dec 2004
Posts: 758
Location: Eureka, Missouri USA
|
| Posted: Fri Jan 22, 2010 5:36 pm Post subject: |
|
|
Hi Shar,
You can replace one of the pulleys with the cordlock so you will not need the second pulley.
The two columns of rings would be placed either 1 or 2 inches in from each edge depending on whether it were going to be inside or outside mounted.
_________________
Thanks,
Debby Bowman
Owner
Shadescapes LLC
800-939-2843
www.make-roman-shades.com |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
Design Based On SwiftBlue Theme created by BitByBit
Powered by phpBB © 2001,
2002 phpBB Group
|
